JEDEC Previews DDR6 With a Wider Bus and Over 50% More Bandwidth

0

 

G.Skill's Trident Z5 RGB DDR5 modules. Future DDR6 modules will be significantly shorter.

JEDEC has previewed DDR6, the next generation of system memory, with a target of more than 50% higher bandwidth than DDR5 at introduction. The DDR6 development preview, released on November 18, outlines a wider data bus, higher transfer rates for registered memory modules, and a shorter module design intended to fit more memory into a system. The figures are development targets and may change before JEDEC approves the standard.

How DDR6 increases bandwidth over DDR5

JEDEC plans to expand the data bus from 64 to 96 data lines, a 50% increase in width. Each transfer can therefore carry more data. Registered DIMMs (RDIMMs), which are commonly used in servers, are expected to start at 12.8 GT/s, compared with the 9.2 GT/s DDR5 RDIMM figure JEDEC cites. The roadmap extends to 14.4 GT/s and beyond. Application performance will depend on how much each workload is limited by memory bandwidth.

More banks and more efficient refresh

JEDEC also plans to organize memory access into pseudo-channels to raise bandwidth per DRAM package. The design doubles the bank count and aims to make refresh more efficient. DRAM cells need periodic refresh to retain data, and the way memory handles those operations affects how much time is available for reads and writes. That matters as systems move to faster modules and pack in more memory.

Shorter modules leave room for more memory

JEDEC describes a 74 mm DDR6 module design, roughly 44% shorter than the 133 mm DDR5 module it uses for comparison. It also plans support for DRAM dies of up to 128 gigabits, equivalent to 16 gigabytes per die, and changes to fit more memory into each package through die stacking. For a desktop DDR5 comparison, the 256 GB Asgard DDR5-6000 kit reaches that capacity using four 64 GB modules. DDR6 module capacities will depend on how manufacturers combine the dies into packages and populate each module.

For servers, JEDEC is targeting better performance per watt through changes to I/O termination and new low-power modes. It also plans to support multiple system-level error-correcting code (ECC) options, giving designers a choice of how to balance reliability, power and cost. JEDEC lists RDIMMs, unbuffered DIMMs (UDIMMs) and compression-attached memory modules (CAMMs) as possible formats. The preview leaves desktop memory speeds and consumer availability open.

Source: JEDEC

Tags:
RAM

Post a Comment

0 Comments

Post a Comment (0)